integrated circuit - Can I combine step-up and step-down designs for switched DC-DC convertor? - Electrical Engineering Stack Exchange

I need to generate 5 volts from unstable source. The voltage on input will be between 2 to 7 volts. The source is hand-crafted dynamo, which I'm doing as an experiment. I found LT1173CN8-5 DIP8

pcb design - Noisy output of 22 V to 5 V buck integrated into a PCB - Electrical Engineering Stack Exchange

integrated circuit - Can I combine step-up and step-down designs for switched DC-DC convertor? - Electrical Engineering Stack Exchange

integrated circuit - DC-DC step up from 3V to over 100V - Electrical Engineering Stack Exchange

Switching voltage regulator - exceeding output voltage limits - Electrical Engineering Stack Exchange

batteries - A DC - DC converter that needs a constant high on the enable pin? - Electrical Engineering Stack Exchange

Step-down Converter - an overview

switch mode power supply - How to make a step down DC-DC converter fail safe? - Electrical Engineering Stack Exchange

mosfet - Automatic power switching between two DC sources with a switch to charging in the second position - Electrical Engineering Stack Exchange

integrated circuit - Boost converter TPS61040 output voltage higher than expected - Electrical Engineering Stack Exchange

A Push-Pull Topology for DC-DC Converter 12 V EV Applications

DC-to-DC Converters: Types, Uses, In-Circuit Design, and Firmware

integrated circuit - Thermal relief for a chip without metal plate on the bottom - Electrical Engineering Stack Exchange

DC/DC Step-Down converter with 1.2-30 V 5A output

10 pcs LM2596 DC-DC Buck Converter Step Down Module Power Supply Output 1.23V-30V

Circuit diagram of the DC-DC step-down converter.

DC-DC Step Down Converters - Zahn Electronics

LM317 DC-DC Converter 5V 6V 9V 12V 24V Voltage Step Down Module Linear Regulator